| One-Inch Monster Tokens |
|
| If you want to upgrade your tokens and prevent wear on the surface, try covering your artwork with a 1" glass marble or epoxy sticker. You can create and print out your own artwork, but we made these with spare RPG cards and scrapbook paper scraps. |
|
|
|
| Epoxy Sticker Monster Tokens: made with our 1" miniature conversion circles , 1" flat back epoxy stickers, and extra RPG cards. We punched the cards with a 1" hole punch and covered each one with an epoxy sticker. Next, we attached a 1" miniature conversion circle to the back of each token. Both the epoxy sticker and our conversion circles already have adhesive, so this is one of the easiest ways to update your tokens. |
|
 |
|
 |
|
|
|
| Supplies: 1" hole punch, 1" miniature conversion circles, 1" flat back epoxy stickers (we found these in the jewelery section of Michael's) and extra RPG cards. |
|
 |
|
|
|
| Glass Marble Skeleton Tokens: made with our 1" miniature conversion circles , 1" flat glass disks, and some spare scrapbook paper. We punched the paper with a 1" hole punch and attached the artwork to one side of the glass disk using Clear Gel Tacky Glue. Next, we attached a 1" miniature conversion circle to the back of each token. |
|
 |
|
 |
|
|
|
| Supplies: 1" hole punch, 1" miniature conversion circles, 1" flat glass disks (we found these on Amazon.com) and scrapbook paper (but you can create and print out your own art as well). |
|
 |
|
|
|
Products used in this project:
|
